America's #1 Direct Source for Pool Supplies!

1.800.288.7946 Experts Available 24/7

Menu
Call Cart
one day delivery

1 Day Delivery

Your ZIP Code: 20149 Ashburn Change Location

To Ashburn Change
Celebrating 35+ Years!
Source / Promo Code:WYAARUNKEdit
cart overlay

    Showing 0 of 0 item View All

    Estimated SUBTOTAL* :  $0.00

    *Excludes taxes, handling fee, and EZ Pay Service Fee, if applicable.
    Source Code:WYAARUNK Edit

    Pro-Strength Polar Winter Pool Cover 12x20 ft Rectangle

    Reliable, Resilient Winter Protection for Your In-Ground Pool with the Pro-Strength Polar Cover

    A strong pool cover is a necessity to protect your in-ground pool throughout the winter, and that’s what you’ll get with the Pro-Strength Polar Winter Cover. You can relax throughout the winter with the peace of mind knowing your pool is protected from falling twigs, leaves and even algae growth. Once spring arrives, uncover your pool and discover your pool will be easier, quicker and less expensive to get going thanks to this tough and durable top-of-the-line construction.

    • Pro-Strength Polar Pool covers are strong but economical
    • Constructed from ultra-durable polyethylene
    • The Pro-Strength Polar cover is triple-dipped for the utmost protection
    • Top coating protects against sun and weather damage
    • In-ground Pro-Strength Polar pool covers are resistant to chemical damage
    • Will provide protection in temperatures down to -50F
    • Heavy-duty water tubes secure this in-ground pool cover
    • Heat-sealed seams prevent water leaks into the pool
    • 12x20ft. rectangular cover with 10 year warranty
      • Item: # W5200 12' x 20' - Pool Size / 17' x 25' - Cover Size / 0 Tubes Now Only! $46.99 Was $52.99
        Note: This cover does not include water tubes.
      • Item: # W5201 12' x 20' - Pool Size / 17' x 25' - Cover Size / 8 Tubes Now Only! $83.50 Was $92.99
      • Customer Review
      • MORE INFO
      Installation Tips

      5 THINGS TO REMEMBER WHEN INSTALLING YOUR WINTER COVER

      1. Be sure to buy the right size cover for your pool. You should not stretch your cover across the pool in an attempt to make it fit. Refer to the diagram below.

       

       



      2. Covers from In The Swim are made to have rain water accumulate on top of them. This water will not damage your cover. Excessive water can be periodically pumped from the cover, but be sure to leave approximately 1 inch of water to protect the cover from wind damage. Be sure not to place the pump on a seam when draining water, as this will cause water from your pool to be drained.

      3. In The Swim covers will accommodate a maximum 18 inch water drop below the top edge of your pool. If you normally drop your cover more than 18 inches, you should order a larger size cover.

      4. Do not use bricks or sharp blocks to weigh your cover down. In The Swim recommends using water tubes or aqua blocks for in-ground pools and cover clips or wall bags for above-ground pools.

      5. If you tie your cover to a fence or other permanent structure, be sure to use a rope with slack to avoid pulling at the cover. This will allow the cover to shift as snow and ice accumulate without pulling out the corner tabs or straps. Water tubes, aqua blocks, cover clips or wall bags should still be used.

      Warranty Year
      You May Also Like...