5 THINGS TO REMEMBER WHEN INSTALLING YOUR WINTER COVER
1. Be sure to buy the right size cover for your pool. You should not stretch your cover across the pool in an attempt to make it fit. Refer to the diagram below.
2. Covers from In The Swim are made to have rain water accumulate on top of them. This water will not damage your cover. Excessive water can be periodically pumped from the cover, but be sure to leave approximately 1 inch of water to protect the cover from wind damage. Be sure not to place the pump on a seam when draining water, as this will cause water from your pool to be drained.
3. In The Swim covers will accommodate a maximum 18 inch water drop below the top edge of your pool. If you normally drop your cover more than 18 inches, you should order a larger size cover.
4. Do not use bricks or sharp blocks to weigh your cover down. In The Swim recommends using water tubes or aqua blocks for in-ground pools and cover clips or wall bags for above-ground pools.
5. If you tie your cover to a fence or other permanent structure, be sure to use a rope with slack to avoid pulling at the cover. This will allow the cover to shift as snow and ice accumulate without pulling out the corner tabs or straps. Water tubes, aqua blocks, cover clips or wall bags should still be used.
