America's #1 Direct Source for Pool Supplies!

1.800.288.7946 Experts Available 24/7

Call Cart
one day delivery

1 Day Delivery

Your ZIP Code: 20149 Ashburn Change Location

To Ashburn Change
Celebrating 35+ Years!
Source / Promo Code:WYAARUNKEdit
cart overlay

    Showing 0 of 0 item View All

    Estimated SUBTOTAL* :  $0.00

    *Excludes taxes, handling fee, and EZ Pay Service Fee, if applicable.
    Source Code:WYAARUNK Edit

    Fine Mesh Winter Pool Cover 16x32 ft Oval


    Fine mesh winter pool covers for above ground pools are designed to allow rain water and melting snow pass through the cover while keeping larger debris from entering your pool water.

    When it comes time to open your pool in the spring, simply remove the cover and vacuum the small amount of silt on the pool floor.

    Fine mesh winter pool covers are an ideal choice for individuals living in climates with a lot of precipitation as they prevent the nasty build-up of water and debris on your cover.

    No cover pump needed! Fine mesh pool cover drains rain & snow melt.

    Cover Clips
    Pool Cover Clips help secure your winter cover to the top of your pool to prevent wind problems. A complete set of clips can be purchased with our fine mesh cover. Cover Clips are not for use with Intex or other portable pools. Cover clips fit most top rails, steel or resin aboveground pools.

    read more
      • Item: # W3840 16' x 32' Oval Pool / 19' x 35' Oval Cover $101.99
        Note: This cover does not include clips.
      • Item: # W3841 16' x 32' Oval Pool / 19' x 35' Oval Cover / 50 Clips $129.97
      • Product Description
      • Customer Review
      • MORE INFO

      During the winter, you can affordably and effectively protect your swimming pool from harsh weather with one of In the Swim's above ground mesh winter pool covers. Fine mesh above ground pool covers collect leaves and falling debris without allowing rain water or snow to build up on your winter cover.

      This woven, fine mesh winter pool cover for aboveground pools prevents the swampy mess that solid pool covers collect. No need to use a cover pump, the water that collects on top simply drains through, and the fine mesh filters out small particulate matter that blows off the cover once dry.

      Only the smallest silt passes through the mesh fabric. Fine mesh covers block sunlight, so that your pool water stays fresh all winter long, and your pool cover stays clean and attractive. Solve your messy pool cover clean-up problem with our fine mesh winter pool cover for above ground pools.

      For even more protection in an aboveground pool winter mesh cover, look at our Micro-Mesh pool covers. Lighter and stronger than our Fine Mesh cover, Micro-Mesh pool covers have an 3-Year limited warranty.

      Installation Tips

      1. Be sure to buy the right size cover for your pool. You should not stretch your cover across the pool in an attempt to make it fit. Refer to the diagram below.

      2. Covers from In The Swim are made to have rain water accumulate on top of them. This water will not damage your cover. Excessive water can be periodically pumped from the cover, but be sure to leave approximately 1 inch of water to protect the cover from wind damage. Be sure not to place the pump on a seam when draining water, as this will cause water from your pool to be drained.

      3. In The Swim covers will accommodate a maximum 18 inch water drop below the top edge of your pool. If you normally drop your cover more than 18 inches, you should order a larger size cover.

      4. Do not use bricks or sharp blocks to weigh your cover down. In The Swim recommends using water tubes or aqua blocks for in-ground pools and cover clips or wall bags for above-ground pools.

      5. If you tie your cover to a fence or other permanent structure, be sure to use a flexible bungie cord. This will allow the cover to shift as snow and ice accumulate without pulling out the corner tabs or straps. Water tubes, aqua blocks, cover clips or wall bags should still be used.