America's #1 Direct Source for Pool Supplies!

1.800.288.7946 Experts Available 24/7

Call Cart
one day delivery

1 Day Delivery

Your ZIP Code: 20149 Ashburn Change Location

To Ashburn Change
Celebrating 35+ Years!
Source / Promo Code:WYAARUNKEdit
cart overlay

    Showing 0 of 0 item View All

    Estimated SUBTOTAL* :  $0.00

    *Excludes taxes, handling fee, and EZ Pay Service Fee, if applicable.
    Source Code:WYAARUNK Edit

    Fine Mesh Winter Pool Cover 12x20 ft Rectangle

    Make Spring Opening a Snap with a Fine Mesh Winter Pool Cover

    Take some of the pain out of spring opening with this durable winter pool cover. Made of a woven fine mesh fabric, this cover keeps debris and leaves out of your pool while letting water and snowmelt pass through, eliminating the heavy, soggy mess that is often associated with opening the pool in the spring.

    This cover is black, with a black underside to prevent algae growth, and includes water bag loops every four feet plus stamped brass grommets at each corner to hold it firmly in place. This cover removes the need to pump water off standing water which is especially useful in areas that receive a lot of precipitation. Its woven mesh design only lets fine silt through, which is easily vacuumed off the pool bottom.

    read more
      • Item: # W3900 12' x 20' - Pool Size / 16' x 24' - Cover Size $71.99
        Note: This cover does not include water tubes.
      • Item: # W3901 12' x 20' - Pool Size / 16' x 24' - Cover Size / 8 Black Double 8ft. Water Tubes $124.16
      • Product Description
      • Customer Review
      • MORE INFO

      • Fine mesh winter pool cover won’t collect water and leave a soggy mess to clean up in the spring
      • Made to fit 12x20 Ft. rectangle in-ground pools
      • Woven mesh fabric lets water through while preventing debris from getting in the pool
      • Comes with durable loops every 4 feet to hold water bags in place
      • All-black coloring prevents algae growth
      • Can be secured via the reinforced grommets at its corners, and/or with water bags or weights
      • Size allows for an 18-in. water drop in a 12x20 Ft. pool
      • Great for areas that get a lot of rain and snow in the winter
      • Makes spring openings easy: simply remove cover and vacuum fine silt off pool bottom
      • Available to buy by itself or with 8 black 8-ft.-long double-chambered water bags to hold it in place
      • Save 10% on double water tubes when purchased with the Micro Mesh Cover
      • 3-year limited warranty; 1-year full warranty

      Installation Tips

      1. Be sure to buy the right size cover for your pool. You should not stretch your cover across the pool in an attempt to make it fit. Refer to the diagram below.

      2. Covers from In The Swim are made to have rain water accumulate on top of them. This water will not damage your cover. Excessive water can be periodically pumped from the cover, but be sure to leave approximately 1 inch of water to protect the cover from wind damage. Be sure not to place the pump on a seam when draining water, as this will cause water from your pool to be drained.

      3. In The Swim covers will accommodate a maximum 18 inch water drop below the top edge of your pool. If you normally drop your cover more than 18 inches, you should order a larger size cover.

      4. Do not use bricks or sharp blocks to weigh your cover down. In The Swim recommends using water tubes or aqua blocks for in-ground pools and cover clips or wall bags for above-ground pools.

      5. If you tie your cover to a fence or other permanent structure, be sure to use a flexible bungie cord. This will allow the cover to shift as snow and ice accumulate without pulling out the corner tabs or straps. Water tubes, aqua blocks, cover clips or wall bags should still be used.