Chlorine Sale! $10 OFF Chlorine & Bromine! Enter Promo Code 99932 at Checkout. Valid only on 25lb+
GLI / CANTAR SAFETY COVER HARDWARE
NOTE: GLI pool cover hardware is not compatible with Meyco or Loop-Loc brand safety covers.
Please click here for Meyco Safety Cover Replacement Hardware
Please click here for Loop-Loc Safety Cover Replacement Hardware
GLI Brass Anchors: Brass cover anchors fit GLI solid or mesh safety covers, (formerly known as Cantar). Threaded brass anchors are the same width as other brass cover anchors, but the threads are a slightly different size. GLI / Cantar brass anchors measure 13/16" diameter, and 1-5/8" tall.
GLI Cover Springs: The stainless steel spring for the GLI safety cover is crafted from high grade stainless steel, and should never rust, unless stored next to your chlorine bucket, in which case surface oxidation crystals can appear. GLI cover springs are 8" long, and should never need replacing, unless your cover experienced a heavy snow load, without the support of water within 18" from the safety cover.
GLI Cover Installation Rod: This is used to pull the springs over the anchor. Slotted on the base to facilitate smooth action. GLI cover tools are made to be extra tall and comfortable in use. The installation rod shipped with your GLI safety cover will never break, but they can get misplaced.
GLI Stainless Steel Buckle: These are the buckles on the GLI cover straps that allow you to adjust the length of the strap. Similar to a buckle on backpack straps, this piece of high quality GLI cover hardware will never rust or break, and usually never get lost. But we have them if you need them!
GLI Short Springs: At 5" in length, short springs are used on mesh or solid safety covers when the edge of the cover comes close to a wall or other obstruction. You can adjust the straps all the way to the end to position the long spring (8") up to the edge of the cover, but for those cases when you need just a few more inches to maintain cover tightness, the short spring by GLI is the answer.
Wood Deck Anchor: GLI wood deck anchors come with 4 brass screws to secure the flange into your wood or composite pool deck. Other brands have only 3 screws and a smaller diameter flange. GLI wood deck anchors are more secure to hold your cover tight in soft wood pool decks.
Tamping Pin: Use the GLI tamping pin to set brass anchors into a concrete pool deck without damaging the body or insert of the brass anchor. Separate the cover anchor into two halves, and insert the tamping pin into the body, and tamp lightly with a medium weight hammer, to press fit the cover anchor into the concrete, until it is sitting just below the level of the top of the concrete deck.
Brass Anchor Collar: For broom finished pool decks, the finishing process entrains some air bubbles into the top surface of the concrete. When installing anchors into concrete, the rotary hammer drill can hit these bubbles and cause the deck to chip slightly, around the drilled hole. Using a new, sharp drill bit can reduce this chipping, or you can use these brass escutcheon plates to hide the chipping and provide a finished look to your GLI brass anchors.
GLI PullTite Double Spring: Absolutely the strongest pool cover spring made. Ingenious design reduces bending and warping of the spring, and allows for more torque, without twisting the springs. If you need to really pull your cover tight, use the GLI / Cantar double spring. They are also make it easier to put the cover on and off with the more open design.