Stop relying on anything less than the best. Instead, turn to the Hayward PowerFlo LX Economy Above Ground Pool Pump, offering maximum performance and power at the lowest possible price. This pump is specifically designed for above ground pools, featuring durable corrosion-proof engineering and a range of innovative features that make it one of the premier economy above ground pumps on the market.
The Power-Flo LX is durable enough to withstand the elements, operates quietly and features a completely drip proof, heat-resistant double-sized seal, extending the lifespan of your motor. It also includes a high-performance impeller, while the transparent cover lets you quickly view when the basket needs to be cleaned. The drain plug makes maintenance a breeze, and the Power-Flo LX ultimately provides a seamless, worry-free pump experience that lets you spend more time enjoying your above ground pool.read more
– Manually check rotation of motor shaft for free movement and lack of obstruction.
– If you have a timer, be certain it is working properly. Bypass it if necessary.
– Low voltage at motor or power drop (frequently caused by undersized wiring or extension cord use).
NOTE: Your Hayward pump motor is equipped with an "automatic thermal overload protector." The motor will automatically shut off if power supply drops before heat damage can build up causing windings to burn out. The "thermal overload protector" will allow the motor to automatically restart once the motor has cooled, provided the power source is again up to proper levels. It will continue to cut On/Off until the problem is corrected. Be sure to correct cause of overheating.
– Binding of motor shaft.
– Make sure all suction and discharge valves are fully open and not blocked, that pool water level is at proper level, and that skimmer weir is not hung up or binded on skimmer wall.
– Block off to determine if pump will develop a vacuum. You should have 5"-6" of vacuum at the strainer cover (Only your pool dealer can confirm this with a vacuum gauge). You may be able to check by removing the skimmer basket and holding your hand over the bottom port with skimmer full and pump running. If no suction is felt, check for line blockage.
Re-check strainer housing cover and all threaded connections for suction leaks. Check if all hose clamps are tight.
Check voltage to ensure that the motor is rotating at full RPM's.
Open housing cover and check for clogging or obstruction in suction. Check impeller for debris.
Remove and replace shaft seal only if it is leaking.
– Plugged or restricted discharge line of filter, valve partially closed (high gauge reading).
How to correct: Sand filters – backwash as per manufacturer's instructions; D.E. filters – backwash
– Air leak in suction (bubbles issuing from return fittings). Re-tighten using Teflon tape.
– Plugged or restricted impeller or impeller sheared off. Replace including new seal assembly.
– Cavitation due to restricted or undersized suction line or leak at any joint, low water level in pool, and unrestricted discharge return lines. Correct suction condition or throttle return lines, if practical. Holding hand over return fitting will sometimes prove this point or putting in a smaller eyeball fitting.
– Vibration due to improper mounting, etc. Put a rubber pad under metal mounting feet.
– Foreign matter in pump housing. Loose stones/debris hitting impeller could be cause, remove any of the above
– Motor bearings noisy from normal wear, rust, overheating, or concentration of chemicals causing seal damage, which will allow chlorinated water to seep into bearings wiping out the grease causing bearing to whine. All seal leaks should be replaced at once.
– Equipment base vibrating.