In The Swim -
Swimming Pool Supplies
Home  |  My Account  |  Help
Source Code: WYAARUNK | October 20, 2014
SHOPPING CART
ITEMS: 0 TOTAL: $0.00
VIEW CART / CHECK OUT
| | | | |


Inventory Blowout Sale!

Polaris® 65 - Automatic Pool Cleaner



Not recommended for use on above ground pools with pumps smaller than 3/4 hp.

Qty. Item No. Description ONLY! 
E1497  
Hot  
Polaris® 65    $199.00  


ZZOD0047   All Purpose Filter Bag   $20.52  


ZZOD0051   8 ft. Hose Extension   $22.91  


For fast, efficient and easy pool cleaning, the Polaris 65 automatic pool cleaner is a great solution. The Polaris 65 pool cleaner is a pressure-side cleaner designed specifically for use in above ground pools. This powerful pool vacuum will sweep and clean the sides and floor of above ground swimming pools and takes just minutes to install. The Polaris 65 automatic pool cleaner features a patented jet sweep assembly which will loosen and remove dirt and debris even from hard-to-reach places.

By removing debris such as dirt and leaves before they can reach the pool's filter, Polaris 65 above ground pool cleaners prevent filters from clogging. This not only reduces filter cleaning by up to 80%, it also extends the overall filter lifespan. Easy to install and easy to use, Polaris 65 automatic pool cleaners eliminate the need for vacuuming by hand and provide the perfect cleaning solution for pool owners who prefer swimming in their pool rather than cleaning it.

Technical Specifications:

  • The Polaris 65 is an above-ground pressure side cleaner.
  • Designed for all aboveground pools up to five feet deep, even those with an uneven bottom.
  • The bottom and sweeps the sides in three hours or less.
  • The Polaris cleaner uses a debris bag and comes with a 24' hose.


  • Back To The Top

    Troubleshooting

  • Polaris does not clean the entire pool or runs slowly.
  • – Verify that the pressure relief valve is releasing water. If it is not, clean or backwash the pool filter.
    – Check the filter screen in the quick disconnect and clean if necessary.
    – Verify that the float hose is the proper length.
    – Remove the surface module top. With the Polaris operating, verify that the randomizer tube is moving back and forth. If it is not moving: Turn off pump, disconnect hoses, look into the mechanism and locate the filter connector inside the randomizer tube. If it is covered with debris or algae, remove the connector chamber, cylinder, and piston. Pull out the randomizer tube and clean the filter connector. If the connector is clean, replace the piston. If it is moving: Watch the randomizer ball in the mechanism. If it does not move within 2 minutes, replace the randomizer tube and piston.
    – Verify that the water pressure is between 5 and 10 psi.

  • Surface module dives under the water or leans to one side.
  • – Straighten twisted hoses.
    – Lift surface module out of the water, empty it and then shake it. If water is still heard inside, remove the top, pull out the drain plug assembly and drain the module.B – Adjust the pressure relief valve until the surface module levels off.
    – Verify that the water pressure is between 5 and 10 psi.

  • The float hose remains coiled.
  • – See “Polaris does not clean entire pool."
    – Lay the float hose out straight in the sun to remove the coils.

  • Surface module moves too fast.
  • – Adjust the pressure relief valve until the surface module slows down.
    – Verify that the water pressure is between 5 and 10 psi.

  • Bag does not stay on the pool floor.
  • – Verify that the bag has been installed correctly.
    – Check for air bubbles around the jet body assembly. This may indicate air in the plumbing lines.
    – See “Surface module moves too fast.”

    Back To The Top

    Frequently Asked Questions:

    Can the Polaris 65 clean dished out pools?
    – Yes! The Polaris 65 is designed for all aboveground pools up to five feet deep, even those with an uneven bottom.

    How long will it take to clean my pool?
    – Installs in minutes. Operates with pumps and filtration systems normally found on aboveground pools and vacuums the bottom and sweeps the sides in three hours or less.

    I have an area of my pool that is hard for most cleaners to reach. Will the Polaris 65 work for me?
    – Patented jet sweep assembly blows water against the pool wall to loosen debris in hard-to-reach places and then sweeps it into an easy-to-remove filter bag.

    Does the Polaris 65 prolong the life of my filter system?
    – The unique filter bag removes debris before it reaches your pump basket or filter, therefore it does prolong the life of the filter system.

    Can I swim while the cleaner is working?
    – NO! All swimmers need to be removed from the pool before starting the Polaris 65 and never handle the cleaner while it is working.

    What kind of technical support does Polaris offer?
    – For on-line support: www.polarispool.com.
    – Or 1-800-822-7933.


    Back To The Top





       « Previous  Product 16 out of 26 in Automatic Pool Cleaners for Above-Ground Pools  Next »   


    Shop the Best Brands in the Pool Business! Visit Our Superstore Pages Below.



     

      SIGN UP FOR WEEKLY EMAIL PROMOTIONS  

    Customer Service
    · Measuring Forms
    · Water Testing
    · FAQs
    · Contact Us

    Shopping
    · My Account
    · Shipping & Tax
    · Returns & Exchanges
    · Order Tracking

     

    Company
    · About Us
    · Employment
    · Privacy & Security
     Catalog
    · Request a Catalog
    · Place a Quick Order

    In The Swim, Swimming Pool Equipment & Supplies, West Chicago, IL
    HACKER SAFE certified sites prevent over 99% of hacker crime.
    In The Swim- America's #1 Direct Source For Pool Supplies

    In The Swim®
    320 Industrial Drive
    West Chicago, IL 60185
    1-800-288-7946